For further information about the NAFS, visit us on the Internet under. This standard has been prepared by NA 026-00-03 AA 'Stanzteile' ('Stamped parts') of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. Deviating requirements and applications shall especially be agreed on. ![]() It applies to plates and wide-flats, hot-rolled on reversing mills, both having a thickness between 4 mm and 50 mm (inclusive) and supplied in the normalized, normalized rolled and as-rolled delivery condition. This standard does not apply for methods of fine blanking. Din 6930 M Tolerance Pdf Free ISO 6930-2:2004 specifies the requirements for weldable high yield strength steels for cold forming. This standard is applied for parts which are exclusively manufactured by stamping methods from flat products with a thickness of more than 0,1 mm and which are, in brief, called stamped parts. The modifications are primarily limited to the currently valid references and an editorial revision. Any requirements and applications deviating shall be settled by special agreement.*This standard is the technical revision of the standard which has been published in 2010-01. This standard does not cover fine banking processes. ![]() This standard applies to parts produced exclusively by stamping processes from flat steel products with a thickness of cover 0,1 mm and called, in short, 'stampings'.
0 Comments
Leave a Reply. |